The perfect ending for a day on the water starts with a stress-free retrieval of your boat—which includes successfully loading it back on its trailer for a safe trip home. Here are some simple step-by-step instructions for navigating that process. Show 10 Tips for Loading a Boat on a Trailer
How to Tie Up a Boat to a Dock Finding the Right Position on Your Trailer If the boat stays afloat all the way to the trailer bow stop, you’ve backed the trailer too far down the ramp. If the boat only floats onto the back third of the trailer, you’re shallow and need to back the trailer in a little deeper. Once you figure out just the right depth, make a note of where the waterline falls on the trailer wheels or fenders, and you’ll always know about where to stop the trailer. If your trailer is positioned properly, it should take minimal power to push the boat up to the winch post. Don’t “power load” the trailer with a lot of engine throttle—your prop thrust will blow away the bottom behind your boat and deteriorate the ramp. Boat Ramp Etiquette As you complete this entire process, remember that idling out of the way of the ramp leaves dock space available for other boaters to utilize while you wait; however, if the ramp area is very quiet, then it’s okay to tie up at the dock. Likewise, it's important to note that you'll want to clear weeds from the trailer and drain your boat at the ramp to prevent the spread of invasive species—this is often required by law. Simply pull the hull drain plug and also drain live or bait wells. While they drain you can secure the transom straps, install an outboard “transom saver” if you use one. Finally, be sure to clear the boat of any loose gear that could blow out on the highway. Before you hit the road, check your tire pressure and the trailer lights, and double check that the trailer coupler is secure on the hitch. Learn More: How to Tow a Boat How to Load a Boat on a Trailer By YourselfYour strategy for retrieving and loading the boat by yourself will depend on the size of the boat; with a bigger boat you may not be able to reach the bow eye from inside the boat. The following is a simple method that works with any boat:
How to Load a Boat on a Roller TrailerIf your trailer supports the boat with rollers rather than bunks, a good strategy is to...
A roller trailer is great for launching and loading at very shallow or unimproved ramps with no dock, as you can easily winch the boat onto the trailer. Loading a Boat on a Trailer in the WindA cross wind or current can complicate the loading process, so there's some additional precautions you'll want to keep in mind.
Read Next: The Ultimate Towing & Trailering Guide You Might Also Like:
two-thirds When retrieving your boat onto a trailer where should you prepare it for the drive home? Prepare for the drive home well away from the boat ramp so that you don’t block ramp traffic. While on land at the ramp area, remove and dispose of all weeds from the vessel and trailer, remove the drain plug to release bilge water, and drain any live wells. When to pull your boat into a launch Lane? The best way to pull the boat in the launch lane is when the towing vehicle has reached the boat ramp as well as the trailer. It is best to retrieve the boat in… wegan837 wegan837 07/15/2017 Physics High School answered You are retrieving your boat from the water. as a courtesy to others, when should you pull your boat into a launch lane? 2 When to drop off a vehicle at a boat ramp?When retrieving, do not pull your vessel into a launch lane until the towing vehicle is at the ramp. The line is formed by vehicles with trailers, not by vessels in the water. Drop off the vehicle driver, and wait offshore and clear of the ramp until he or she arrives with the trailer. Do you have to unhook the winch when launching a boat? When you slowly begin your descent down the ramp, be advised against unhooking the bow of your boat before you get to the edge of the water as it can cause severe accidents. At the edge of the water, leave your tow vehicle (ensure you park it) and unhook the safety chain from the bow of your boat with the winch strap still left hooked up. Can you back your boat down a boat launch? Never do this on the boat launch, the boat launch is for getting in and out of the water quickly. Once you are all loaded, you can begin the launch. Step 2 – Once the coast is clear and it’s your turn, you can now begin to back your boat down the boat launch. Stop once the trailer tires start to get submerged.
If you have a trailer boat, you already know that one of the most stressful parts of any day is launching and retrieving. (Read 5 Tips for Launching a Boat Single-Handed, to see some tips on doing the chore by yourself). And one of the biggest reasons why people botch a launch or a retrieve is because they don’t submerge the trailer far enough. Another big reason? They submerge the trailer too far. Don’t back down the ramp far enough, and the boat won’t drive onto the trailer no matter how hard you try. Sure, you can usually winch on the boat, but most packages are actually designed for driving the boat on—and winching, especially over a dry bunk trailer, can put a lot of stress on the winch, the strap or cable, and the bow eye. (On most roller trailers, it’s not nearly as big a deal). On the flip side, if you back down too far and the trailer doesn’t catch the bow because it’s completely submerged, you might drive right past the bunks or rollers and smash the bow into the bowrest, drive the keel across the trailer frame, or even crash into the back of your truck. Don’t laugh—I’ve seen it happen. Just how deep you should place the trailer for retrieval is best determined when you’re launching it. Back down far enough that the stern of the boat begins to float, but the bow of the boat is still resting on the trailer. That should make it easy to pull the boat both on and off the trailer under its own power. Savvy trailer boaters mark the trailer where it meets the water so they can tell at a glance when they have it in the right spot. If only it were that simple… Naturally, those of you who have owned trailer boats for an extended period of time know that all ramps are not created equal. They have different grades, and if you regularly launch at one with a steep grade then one day travel to a ramp with a much shallower grade, the mark you made might not be the best place to launch from. In fact, your boat might be sitting high and dry… or on the flip side, might float free of the trailer. The bottom line? A healthy dose of common sense needs to be applied, each and every time you launch or retrieve your boat. |