Show
The term incident can be defined as an occurrence, condition, or situation arising in the course of work that resulted in or could have resulted in injuries, illnesses, damage to health, or fatalities. The term "accident" is also commonly used, and can be defined as an unplanned event that interrupts the completion of an activity, and that may (or may not) include injury or property damage. Some make a distinction between accident and incident. They use the term incident to refer to an unexpected event that did not cause injury or damage that time but had the potential. "Near miss" or "dangerous occurrence" are also terms for an event that could have caused harm but did not. Please note: The term incident is used in some situations and jurisdictions to cover both an "accident" and "incident". It is argued that the word "accident" implies that the event was related to fate or chance. When the root cause is determined, it is usually found that many events were predictable and could have been prevented if the right actions were taken - making the event not one of fate or chance (thus, the word incident is used). For simplicity, we will now use the term incident to mean all of the above events. The information that follows is intended to be a general guide for employers, supervisors, health and safety committee members, or members of an incident investigation team. When incidents are investigated, the emphasis should be concentrated on finding the root cause of the incident so you can prevent the event from happening again. The purpose is to find facts that can lead to corrective actions, not to find fault. Always look for deeper causes. Do not simply record the steps of the event. Reasons to investigate a workplace incident include:
Ideally, an investigation would be conducted by someone or a group of people who are:
Some jurisdictions provide guidance such as requiring that the incident must be conducted jointly, with both management and labour represented, or that the investigators must be knowledgeable about the work processes involved. Members of the team can include:
Note: In some cases, other authorities may have jurisdiction, such as if a serious injury or fatality occurred. Your organization should establish, implement, and maintain a procedure to coordinate managing incidents with the authority having jurisdiction (e.g., police, OH&S inspectors, etc.). This coordination may include the authority taking control of the incident scene.
The advantage is that this person is likely to know most about the work and persons involved and the current conditions. Furthermore, the supervisor can usually take immediate remedial action. The counter argument is that there may be an attempt to gloss over the supervisor’s shortcomings in the incident. This situation should not arise if the incident is investigated by a team of people, and if the worker representative(s) and the investigation team members review all incident investigation findings and recommendations thoroughly.
An investigator or team who believe that incidents are caused by unsafe conditions will likely try to uncover conditions as causes. On the other hand, one who believes they are caused by unsafe acts will attempt to find the human errors that are causes. Therefore, it is necessary to examine all underlying factors in a chain of events that ends in an incident. The important point is that even in the most seemingly straightforward incidents, seldom, if ever, is there only a single cause. For example, an "investigation" which concludes that an incident was due to worker carelessness, and goes no further, fails to find answers to several important questions such as:
An inquiry that answers these and related questions will probably reveal conditions that are more open to correction.
First:
The incident investigation team would perform the following general steps:
The organization would then:
As little time as possible should be lost between the moment of an incident and the beginning of the investigation. In this way, one is most likely to be able to observe the conditions as they were at the time, prevent disturbance of evidence, and identify witnesses. The tools that members of the investigating team may need (pencil, paper, camera or recording device, tape measure, etc.) should be immediately available so that no time is wasted.
Many models of causation have been proposed, ranging from Heinrich's domino theory to the sophisticated Management Oversight and Risk Tree (MORT). The simple model shown in Figure 1 attempts to illustrate that the causes of any incident can be grouped into five categories - task, material, environment, personnel, and management. When this model is used, possible causes in each category should be investigated. Each category is examined more closely below. Remember that these are sample questions only: no attempt has been made to develop a comprehensive checklist. Figure 1: Incident Categories TaskHere the actual work procedure being used at the time of the incident is explored. Members of the investigation team will look for answers to questions such as:
For most of these questions, an important follow-up question is "If not, why not?" MaterialTo seek out possible causes resulting from the equipment and materials used, investigators might ask:
Again, each time the answer reveals an unsafe condition, the investigator must ask why this situation was allowed to exist. Work EnvironmentThe physical work environment, and especially sudden changes to that environment, are factors that need to be identified. The situation at the time of the incident is what is important, not what the "usual" conditions were. For example, investigators may want to know:
PersonnelThe physical and mental condition of those individuals directly involved in the event must be explored, as well as the psychosocial environment they were working within. The purpose for investigating the incident is not to establish blame against someone but the inquiry will not be complete unless personal characteristics or psychosocial factors are considered. Some factors will remain essentially constant while others may vary from day to day:
ManagementManagement holds the legal responsibility for the safety of the workplace and therefore the role of supervisors and higher management and the role or presence of management systems must always be considered in an incident investigation. These factors may also be called organizational factors. Failures of management systems are often found to be direct or indirect causes. Ask questions such as:
This model of incident investigation provides a guide for uncovering all possible causes and reduces the likelihood of looking at facts in isolation. Some investigators may prefer to place some of the sample questions in different categories; however, the categories are not important, as long as each question is asked. Obviously there is considerable overlap between categories; this overlap reflects the situation in real life. Again it should be emphasized that the above sample questions do not make up a complete checklist, but are examples only.
The steps in the investigation are simple: the investigators gather data, analyze it, determine their findings, and make recommendations. Although the procedures are seemingly straightforward, each step can have its pitfalls. As mentioned above, an open mind is necessary in an investigation: preconceived notions may result in some wrong paths being followed while leaving some significant facts uncovered. All possible causes should be considered. Making notes of ideas as they occur is a good practice but conclusions should not be made until all the data is gathered. Physical EvidenceBefore attempting to gather information, examine the site for a quick overview, take steps to preserve evidence, and identify all witnesses. In some jurisdictions, an incident site must not be disturbed without approval from appropriate government officials such as the coroner, inspector, or police. Physical evidence is probably the most non-controversial information available. It is also subject to rapid change or obliteration; therefore, it should be the first to be recorded. Based on your knowledge of the work process, you may want to check items such as:
You may want to take photographs before anything is moved, both of the general area and specific items. A later study of the pictures may reveal conditions or observations that were missed initially. Sketches of the scene based on measurements taken may also help in later analysis and will clarify any written reports. Broken equipment, debris, and samples of materials involved may be removed for further analysis by appropriate experts. Even if photographs are taken, written notes about the location of these items at the scene should be prepared. Witness AccountsAlthough there may be occasions when you are unable to do so, every effort should be made to interview witnesses. In some situations witnesses may be your primary source of information because you may be called upon to investigate an incident without being able to examine the scene immediately after the event. Because witnesses may be under severe emotional stress or afraid to be completely open for fear of recrimination, interviewing witnesses is probably the hardest task facing an investigator. Witnesses should be kept apart and interviewed as soon as possible after the incident. If witnesses have an opportunity to discuss the event among themselves, individual perceptions may be lost in the normal process of accepting a consensus view where doubt exists about the facts. Witnesses should be interviewed alone, rather than in a group. You may decide to interview a witness at the scene where it is easier to establish the positions of each person involved and to obtain a description of the events. On the other hand, it may be preferable to carry out interviews in a quiet office where there will be fewer distractions. The decision may depend in part on the nature of the incident and the mental state of the witnesses. InterviewingThe purpose of the interview is to establish an understanding with the witness and to obtain his or her own words describing the event: DO...
DO NOT...
Ask open-ended questions that cannot be answered by simply "yes" or "no". The actual questions you ask the witness will naturally vary with each incident, but there are some general questions that should be asked each time:
Asking questions is a straightforward approach to establishing what happened. But, care must be taken to assess the accuracy of any statements made in the interviews. Another technique sometimes used to determine the sequence of events is to re-enact or replay them as they happened. Care must be taken so that further injury or damage does not occur. A witness (usually the injured worker) is asked to reenact in slow motion the actions that happened before the incident. Other InformationData can be found in documents such as technical data sheets, health and safety committee minutes, inspection reports, company policies, maintenance reports, past incident reports, safe-work procedures, and training reports. Any relevant information should be studied to see what might have happened, and what changes might be recommended to prevent recurrence of similar incidents.
At this stage of the investigation most of the facts about what happened and how it happened should be known. This data gathering has taken considerable effort to accomplish but it represents only the first half of the objective. Now comes the key question - why did it happen? Keep an open mind to all possibilities and look for all pertinent facts. There may still be gaps in your understanding of the sequence of events that resulted in the incident. You may need to re-interview some witnesses or look for other data to fill these gaps in your knowledge. When your analysis is complete, write down a step-by-step account of what happened (the team’s conclusions) working back from the moment of the incident, listing all possible causes at each step. This is not extra work: it is a draft for part of the final report. Each conclusion should be checked to see if:
This list serves as a final check on discrepancies that should be explained.
The most important final step is to come up with a set of well-considered recommendations designed to prevent recurrences of similar incidents. Recommendations should:
Resist the temptation to make only general recommendations to save time and effort. For example, you have determined that a blind corner contributed to an incident. Rather than just recommending "eliminate blind corners" it would be better to suggest:
Never make recommendations about disciplining a person or persons who may have been at fault. This action would not only be counter to the real purpose of the investigation, but it would jeopardize the chances for a free flow of information in future investigations. In the unlikely event that you have not been able to determine the causes of an incident with complete certainty, you probably still have uncovered weaknesses within the process, or management system. It is appropriate that recommendations be made to correct these deficiencies. The Written ReportThe prepared draft of the sequence of events can now be used to describe what happened. Remember that readers of your report do not have the intimate knowledge of the incident that you have so include all relevant details, including photographs and diagrams. Identify clearly where evidence is based on certain facts, witness accounts, or on the team’s assumptions. If doubt exists about any particular part of the event, say so. The reasons for your conclusions should be stated and followed by your recommendations. Do not include extra material that is not required for a full understanding of the incident and its causes such as photographs that are not relevant and parts of the investigation that led you nowhere. The measure of a good report is quality, not quantity. Always communicate your findings and recommendations with workers, supervisors and management. Present your information 'in context' so everyone understands how the incident occurred and the actions needed to put in place to prevent it from happening again. Some organizations may use pre-determined forms or checklists. However, use these documents with caution as they may be limiting in some cases. Always provide all of the information needed to help others understand the causes of the event, and why the recommendations are important.
A difficulty that has bothered many investigators is the idea that one does not want to lay blame. However, when a thorough worksite investigation reveals that some person or persons among management, supervisor, and the workers were apparently at fault, then this fact should be pointed out. The intention here is to remedy the situation, not to discipline an individual. Failing to point out human failings that contributed to an incident will not only downgrade the quality of the investigation, it will also allow future incidents to happen from similar causes because they have not been addressed. However never make recommendations about disciplining anyone who may be at fault. Any disciplinary steps should be done within the normal personnel procedures.
Management is responsible for acting on the recommendations in the investigation report. The health and safety committee or representative, if present, can monitor the progress of these actions. Follow-up actions include:
Document last updated on November 26, 2019
Contact our Safety InfoLine 905-572-2981 Toll free 1-800-668-4284 (in Canada and the United States) |